Clik here to view.
License Plate Restoration
Tech article by Jacob Schreiber (Schreiber) Although ClassicBroncos.com covers almost every Bronco project imaginable, one I’ve never seen is a write-up on restoring original license plates. This is an...
View ArticleClik here to view.
3 Arm Wiper Set Up Below the Windshield Frame
Tech article by Chris (taipeichris) I’ve owned my 66 Bronco since August 2004 and my wipers never did a good job. I live in Los Angeles it really doesn’t rain much but almost every morning the entire...
View ArticleClik here to view.
How to Fix a Broken Motor Mount for About $1.00
Tech article by Chris (taipeichris) For numerous reasons I broke motor mounts in the past, usually I’d find out when I’d hit a bump in the road and the motor jumps up enough to hit the hood. Not cool,...
View ArticleClik here to view.
Clean Windsheild Braces to Roll Cage
Tech Article by Ted Howard (Tedster100) As I worked on my build I have realized that bracing the windshield to the roll cage is a great idea. It offers support to the windshield when the top is off...
View ArticleClik here to view.
Convert a Mustang 55mm throttle body to a 65mm Explorer
Tech article by Chuck (blazinchuck) Before you can slap that Explorer throttle body on, a few things need to be changed. The throttle lever is indexed wrong and needs to be swapped with the one from...
View ArticleClik here to view.
Bronco wheel alignment adventure
Tech article by Phil Dawson (phldwsnoc1) After a career of making suspension repairs and improvements to a wide variety of vehicles, it was time to see if I could do the same for my Bronco. Designed...
View ArticleClik here to view.
Early Bronco Heat Riser Replacement
Tech article by Mike Kipper (Kip60) I purchased a mostly original 1970 Sport last year. It didn’t run when I got it. Started with rebuilding the carburetor. Finally got it to run, but a little rich....
View ArticleClik here to view.
Early Bronco Vent Window Repair
Tech article by Bronco-Brian Transform your broken pivot base back to stronger support than OEM without using rivets. This job takes about 10-minutes once the window is free from the outer housing....
View ArticleClik here to view.
Center Console Mount
Center Console Mounting Bracket in an Early Bronco Tech article by Mike Kipper (kip60) After finally fixing the rust in the floorboards, it was time to put everything back in and make sure it fit in...
View ArticleClik here to view.
How to straighten a Bronco bumper
Tech article by Chris (taipeichris) How to straighten a bent factory rear or front bumper with the bumper still installed. Tools Required: 1 pair safety glasses 1 pair leather gloves 1 medium hand held...
View Article
